Antares AMM-1 Spezifikationen PDF herunterladen (Seite 28)

The MIDI SysEx message to defeat Bypass is:

F0 00 01 26 11 03 F7

The accompanying LED lights to remind you that you are in Bypass

Mode, whether the mode was initiated by the Bypass button, the

footswitch, or MIDI.

Output Level

The Output Level control is used to fine-tune the AMM-1’s output

level. Turning the Output Level knob will temporarily display the

Output Level value on the LCD:

Output Level (dB)

-04.5

This control is strictly an attenuator (i.e., no gain is available). You

should always start with it at 0dB (its maximum value) and then

reduce level as necessary. It is particularly useful when adding large

amounts of tube saturation.

System Edit

Pressing the SYSTEM button at any time will place the AMM-1 in

System Edit mode. The System Edit pages allow you to set param-

eters which affect the AMM-1 globally, as well as to access the

FLASH Model Management functions.

When is System Edit mode, the Microphone, Proximity and Low Cut

buttons function according to their secondary red labels (i.e., as

Cursor, Page and Enter buttons).

Navigation

Press the Page button to cycle sequentially through the available

edit pages. You can only move in one direction, but there are so few

pages in System mode that you are never more than a few presses

away from where you want to be.

If a page includes more than one editable field, Press the Cursor

button to move from field to field.

After you have finished making changes, press the SYSTEM button

again to return to normal operation.

Bypass/Output Level/System Edit

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 49 50

Keine Kommentare

Antares AMM-1 Spezifikationen Seite 28